
NTI NODEMUX SERIES UNIVERSAL KVM SWITCH
11
USB CPU SUPPORT
(Optional)
Introduction
The NTI ST-2U-U UNIVERSAL KVM Switch has 2 additional female USB type B ports that allow USB compatible CPUs (SUN,
MAC, or WINxx) to be connected to the switch.
General Notes
The ST-2U-U should have all cables attached before powering up. If no cable is plugged into either of the 8 pin miniDIN CPU
ports labeled CPU 1 or CPU 2 (see Fig. 15) on the ST-2U-U, then their respective USB ports labeled for CPU 1 USB and CPU 2
USB on the ST-2U-U will become the default active CPU port(s).
The USB ports on the ST-2U-U are HOT PLUGGABLE.
The 8 pin miniDIN cables are not HOT PLUGGABLE. They must be plugged in at power up to operate correctly.
Figure 14- USB device ports on the ST-2U-U
Keyboard translation
The chart below shows the capabilities of devices controlling certain CPU types through the ST-2U-U KVM switch.
CPUSKEYBOARDS
PS/2 (WINxx) SUN MAC USB (SUN) USB (MAC) USB (WINxx)
PS/2
Normal See charts
on pg. 10
See charts
on pg. 10
See charts
on pg. 10
See charts
on pg. 10
Normal
SUN 5C
Normal Normal Normal Normal Normal Normal
MAC ADB
Normal No SUN
translation
Normal No SUN
translation
Normal Normal
Normal= No translation necessary- keyboard functions normally
Cables
Connect the USB CPU to the NTI ST-2U-U KVM switch using a USB-AB-xx cable (not supplied).
LED Operation
The LEDs do not operate as described earlier in this manual for the ST-2U for SCAN and BROADCAST.
• For SCAN- the LED does not flash. The LED stays on continuously while the indicated port is active.
• For BROADCAST- both LEDs might not illuminate, depending on the type of CPU connected.
12
4 3
6 5
U S E R
12
4 3
6 5
12
4 3
6 5
M O N I T O R
C P U 1
C P U 2
6
6
6
6
6
6
V I D E O 2
V I D E O 1
C P U 2
U S B
C P U 1
U S B
U S B
P o r t s
R e a r V i e w o f S T - 2 U - U
8 p i n m i n i D I N
u s e r p o r t s
9 V D C
. 5 A
-
+
Commentaires sur ces manuels