Network-technologies CAT5 Manuel d'utilisateur télécharger pdf (Page 46)

HA-RS Configuration

The HA-RS Serial Host Adapter enables a user to remotely connect to a serial device and control the device using the PRIMUX

User Station as a terminal. The HA-RS is compatible with most serial devices with an RS232 port. The HA-RS emulates a

VT100 terminal – converting serial data from an ASCII device into VGA video (800x600 @ 60Hz signal).

Note: The HA-RS Host Adapter will only work with User Stations programmed with firmware version 2.0 and later.

Note: All Host Adapters must be programmed with firmware version 2.0 in order to work with a User Station programmed

with firmware version 2.0 and later. See “Please Note...” on page i.

When connecting to an HA-RS through Command Mode (page 19) a terminal screen will be presented with a connection to the

serial device. The terminal screen will include available functions for the user interface listed at the bottom.

Figure 41- HA-RS User Interface

The user can either communicate to the serial device or use the <Ctrl> key in conjunction with <Fx> keys to control the colors of

the interface, the connection parameters of the HA-RS, or view up to 10 pages of data that has been viewed through the HA-RS

from the serial device. Control options are as follows:

Key Strokes Function

<Ctrl>-<F1> Help Menu

<Ctrl>-<F2> Setup Screen to setup connection parameters

<Ctrl>-<F3> Setup Programmable keys

<Ctrl>-<F4> View the stored data in the buffer

<Ctrl>-<S> Stop displaying output from host (serial device)

<Ctrl>-<Q> Resume displaying output from host (serial device)

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 52 53 54

Pas de commentaire

Network-technologies CAT5 Manuel d'utilisateur Page 46